Cisco asa 8.3 gns34/17/2024 ![]() Which allows Cisco to securely receive minimal error and health Help to improve the ASA platform by enabling anonymous reporting, Running Permanent Activation Key: 0xcb10d26a 0xa440851c 0xc9326500 0xdaa01818 0xc325eabcĬonfiguration has not been modified since last system restart. This platform has an ASA5525 VPN Premium license. Maximum Physical Interfaces : Unlimited perpetualĪn圜onnect Essentials : Disabled perpetualĪn圜onnect for Mobile : Disabled perpetualĪn圜onnect for Cisco VPN Phone : Disabled perpetualĪdvanced Endpoint Assessment : Disabled perpetualīotnet Traffic Filter : Disabled perpetual SSL/IKE microcode : CNPx-MC-SSL-SB-PLUS-0005 Hardware: ASA5525, 8192 MB RAM, CPU Lynnfield 2394 MHz, 1 CPU (4 cores)īIOS Flash MX25L6445E 0xffbb0000, 8192KBĮncryption hardware device : Cisco ASA Crypto on-board accelerator (revision 0x1) System image file is "disk0:/asa942-11-smp-k8.bin" ![]() WARNING: Failover is enabled but standby IP address is not configured for this interface.Ĭisco Adaptive Security Appliance Software Version 9.4(2)11Ĭompiled on Mon 22-Feb-16 22:54 PST by builders ![]() I explictily configure the standby IP address on the 'inside' interface since we're doing HSRP and allocate a /29 subnet.ĪSA01/pri/act(config-if)# ip address 202.78.4.6 255.255.255.128 The standby keyword is normally used in Active-Active failover where each context monitors its interface and activates failover if it multiple failed interfaces were detected. For example, if you've got limited public IP address range, you can just configure the 'outside' interface with a single public IP address. You can optionally skip the standby IP address under the context configuration and failover (and routing) would still work. I also confirmed with Cisco TAC that a 20-Security Context license ASA5500-SC-20 (vs L-ASA-SC-20) will work on a Cisco ASA 5500-X platform. The Secondary/Standby unit will inherit the Primary license when it becomes Active. You just buy and only install the license for the Primary/Active firewall unit. Before its deployment, I've upgraded both ASA to the latest code 9.4(2)11, applied and configured the 10-security context license (multiple mode).Īccording to Cisco ASA 5500-X Configuration Guide starting ASA 8.3(1), you don't need to install identical licenses (with some exceptions) on both firewall units. I've posted a blog a couple years back regarding this setup in a GNS3 environment but now I'm deploying it in the real world. I had a remote site with two Cisco ASA 5525-X firewalls deployed as an Active-Standby failover pair.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |